BILT Speaker

BILT Speaker
RevitCat - Revit Consultant

Tuesday 25 April 2017

Deleting Global Parameters in Revit

Following on from my earlier post about transferring global parameters between Revit projects, here is some information about what happens when you delete them.

Your list of Global Parameters in a project can get very long and messy - so eventually you'll need to do some tidying up.

Global Parameters Dialog Box


The Global Parameter dialog box has a 'Delete' function, not surprisingly - a red cross icon, next to the modify and create new icons.

A Global Parameter (GP) can be used in formulas for other parameters, and it can be associated to dimensions or elements in the project, so you need to be careful about deleting them - more so than in the family editor (where you have a better chance of knowing where they'd been used).

If a GP is deleted, then any formulas using that GP would also be cleared - it gives a warning, which is invaluable



If a GP is deleted, where it has been associated to elements, it also gives a warning with a number of elements to be affected - if you proceed all those associations would be lost. By comparison, in the family editor deleting a parameter would affect only that family, whereas with Global Parameters it could affect the whole project. So, be very careful

Elements in the Project

Elements in a project could have GPs associated with them, and deleting the element would obviously break/lose that association.  It is important to know when this is happening - or better still, beforehand.  When a dimension is deleted, it will warn you about constraints;  it does the same thing for GP associations to dimensions.
 

If you expand the warning it does not mention global parameters, but gives enough information to figure it out

Warning
If you delete an element that has a GP directly associated to one of its properties, it does not warn you - Revit just goes ahead and deletes it.  For this reason it is important to be able to check which elements have associations

Checking GP Associations


When you select an element that has GP controlled dimensions attached to it, all the related GPs show up on screen, including the label names. You can hover the cursor over any of the highlighted constraint dimensions for more detail in a popup tooltip.
 

It is a mystery why all those extra label names appear in this situation but not when you select an actual dimension. Sometimes it gets very messy and confusing

More on checking GP Associations by scheduling and view filters to follow . . . .

No comments:

Post a Comment